When it is time to use a snowblower, you are going to have certain situations where the safety switch is going to get in the way.
It’s important to note that manufacturers add a safety switch on a snowblower for a reason and that it should remain functional if you want to stay safe.
However, if there is a time when you are not going to want the safety switch on a snowblower to work, it’s important to learn how to bypass a kill switch on a snowblower.
To bypass a kill switch on a snowblower, shut down the engine first. Next, look for the main safety switch (button or key) and check the cover plate. This cover plate is going to have to be removed to get to the wires underneath. Disconnect all of these wires and that will kill the switch.
As mentioned before, it is not good to bypass the kill switch on a snowblower and it should only be done when it is mandatory.
This article is going to show you how to bypass a kill switch on a snowblower and what is required to do so safely.
Table of Contents
Steps On How To Bypass A Kill Switch On A Snowblower
1. Shut Down The Engine
Before you take the time to turn off the kill switch on a snowblower, you have to ensure power is not running through to it at the time of your change.
You will want to ensure it is completely disconnected.
The reason you are going to want to do this is for your safety. You do not want the snowblower to start up as soon as you begin working on the wires for the safety switch.
This is when you are going to get hurt.
You will want to shut down the engine and make sure the snowblower is not going to start up on its own. This is a must.
2. Look For The Main Safety Switch (Read Owner’s Manual)
Now, you are going to want to take out the owner’s manual.
If you know where the safety switch is then you are not going to have to go through the manual. However, for those who are going to be using this switch for the first time, it is best to become aware of what you are going to be digging through.
Otherwise, you are going to be taking a serious risk when it comes to the changes you are making to the snowblower.
The best option is to look for the main safety switch.
The average snowblower is going to have a button that is used for this purpose. While older models are going to have a key.
Just go through the owner’s manual to see which one applies to your make and model.
3. Remove The Cover Plate Near the Switch
You are now going to know where the safety switch is in a snowblower.
This is a good start.
The goal here is to see how the safety switch is protected because your main interest is going to be in the wires underneath.
It is how you are going to turn off the safety switch in a snowblower safely.
The best way to do this is to take off the cover plate that is in the way. This plate is where you are going to want to start and it is not going to take long to remove.
4. Disconnect All Of The Wires
You are going to now have access to the wires that are holding the safety switch in place.
This is a good sign.
This is where you are going to want to move your focus to.
The idea here is to take off all of the wires and make sure they are not linking back to the main safety switch.
You should take a picture for later to ensure you are not removing the wires in a manner that you are not going to know how to put them back later.
Look into this and then remove the wires.
It is these steps that will help as you learn how to bypass a kill switch on a snowblower.
To bypass a kill switch on a snowblower, it’s best to start by turning off the main engine. Next, locate the main safety switch by reading through the owner’s manual. It is commonly going to be a small button. Next, remove the cover plate around the switch and then disconnect all of the wires.
At this point, the safety switch is going to stop working, which is what you want.
Always remember how you took off the wires because you are going to want to put them back into place later. It is best to have this knowledge to get the snowblower to work properly again.