It’s disconcerting to have a situation where the log splitter is not functioning as you want it to.
This can cause all sorts of issues including the logs not splitting as required or the machine coming to a halt in the middle of a session.
This is why most log splitter owners will look at maintaining their machine and ensuring it continues to run whenever they turn it on.
One issue people report from time to time is when the log splitter ram won’t move.
If the log splitter ramp won’t move, it’s best to top up the fluids, ensure the relief valve is fully open, and check if it is plugged in. In some cases, it can also be a damaged hose that needs to be replaced.
Going through these potential reasons will be a good way to make sure the log splitter ram does move.
For the most part, it is going to be one of these reasons.
Look at finding out how to fix the log splitter ram that won’t move with the help of these steps. You are going to be well on your way to seeing great results as long as you do this.
Table of Contents
How To Fix Log Splitter Ram That Won’t Move
1. Top Up The Fluids
Have you taken the time to check the fluids in the log splitter?
The log splitter ram is not going to move if the hydraulic fluid is not full. This is a common mistake that is made, especially by those who have not used the log splitter in a while and then take it out for a longer work session.
Yes, it might work but it might also create issues such as this one.
You will immediately want to take a look at the hydraulic fluid in the log splitter. If it is low, you will want to top it up as soon as you can.
This is how you are going to get the log splitter to move again and it will happen right away. It is best to keep track of the fluids in the log splitter throughout the year to make sure they are full.

2. Open The Relief Valve
You are now going to move on to the relief valve.
This is a key part of the log splitter and this is one of the main reasons the log splitter ram is not going to move the way you want it to.
The goal is to make sure the relief valve is in the open position.
If it is not in the open position, the log splitter is not going to budge. This is why you have to keep tabs on the valve and ensure it is not stuck in the closed position.
3. Plug in The Machine Properly
Just like you are going to want to take a peek at the relief valve to see that it is open, you also want to take the time to plug the machine in.
This is a common mistake that is made and it is often the root cause of the problems you are dealing with.
When the log splitter won’t budge and you don’t seem to get any power to it, the main issue has to do with the plug.
Look at the plug to see if it is working and whether or not it is plugged in. This is a must or the machine is not going to have enough power to work.

4. Check The Hose For Damage
You will also want to take the time to inspect the log splitter’s hose.
The hose is an integral part of how the fluid moves and you are going to want to ensure it is intact. If it is worn down, this is going to be the reason for your problem.
Sometimes, the hose is going to seem good from afar but then you are going to see a small crack in it as you look deeper.
This is why you have to be patient with what you are doing and how you are keeping track of the log splitter’s health.
Final Thoughts
It’s best to follow this advice when the log splitter ram won’t move.
If the log splitter ram won’t move, start by checking to see that it is plugged in and that the hydraulic fluid is full. If this is the case, check the hose for potential damage and then set the relief valve to the open position to make sure the machine works.
It’s important to look into this as you are learning more about what works and what does not for your health.
You will want to keep tabs on this to ensure you are not cutting corners. This is how mistakes are made along the way.
Focus on this and you will see great results.