When you take out a snowblower, it should move around as you want it to.
This can create a frustrating situation where the snowblower is not getting to where it needs to be. This can also include a situation where the snow blower is unable to pick up snow and/or produce effective results.
This is an issue you are going to have to think about when it comes to a snowblower that won’t move forward or backward.
If a snowblower won’t move forward or backward, the most common reason has to do with a lack of pressure on the friction disc. To fix this, remove the bottom plate, inspect the cable going to the gear lever, depress the lever, and adjust the pressure applied to the disc.
This is the best way to make sure the snowblower starts moving around as it needs to.
Here is more on what you need to consider if the snowblower won’t move forward or backward.
Table of Contents
How To Manage A Snowblower That Won’t Move Forward Or Backward
1. Remove The Bottom Plate
If a snowblower won’t move forward or backward, you are going to need to start with a comprehensive assessment of the bottom plate.
A lot of issues rise when it comes to how the friction disc is doing in the snowblower.
To access this part, you will need to remove the bottom plate.
This is going to give you complete access to the disc, gear lever, and the cable running to the part. It is important to inspect all of these to see where the issue lies when it comes to the overall setup.
When you are removing the bottom plate, it is important to make sure you are aware of where everything goes.
This will make it easier to put the bottom plate back into place when you are done with the friction disc.

2. Check The Cable Going To The Gear Lever
You will also want to look at the cable going to the gear lever once the bottom plate is out of the way.
This cable is going to be noticeable and it will be running from the gear lever to the friction disc. The reason you want to check this is to see whether or not there is a lack of pressure due to the cable being damaged.
When there is a lack of pressure, this can cause major issues with how the snowblower moves around.
This includes both on a hard surface and when there is snow on the ground.
You will want to look at the gear lever in detail to see how it is set up and how it needs to be adjusted.
3. Depress The Lever
You will always want to depress the lever.
This is a common mistake people make when it comes to how the lever is set up and how it has to be set up.
There is nothing worse than having a situation where the lever is too loose.
If the lever is too loose or not set in the right place, it is going to create a situation where the friction disc does not stay level.
This will become the reason for the snowblower not moving around as it needs to.
The best solution when this happens is to make sure you are adjusting the pressure on the disc.

4. Adjust The Pressure On The Disc
The goal now is to adjust the pressure on the friction disc.
When you place your hand on the friction disc, you will realize it is either going to spin or not. If it spins, this means the friction disc is fine and it is moving to allow the snowblower to get to where it needs to.
However, if it is stuck, this means there is too much pressure on the friction disc and it is time to adjust the setup.
If you are not taking the time to do this, you are not going to see the snowblower move around as you want it to.
Final Thoughts
Look into these steps if the snowblower won’t move forward or backward.
If the snowblower won’t move forward or backward, this means the friction disc is causing problems. To fix the issue, remove the bottom plate, inspect the cable running from the gear lever, depress the lever, and adjust how much pressure is being applied to the disc.
At one point, it will ensure the snowblower moves as it needs to.
It is essential to think about what you are doing when it comes to the snowblower. If you are not careful, the snowblower is going to break and you are going to have serious issues with how it moves around from point A to point B.
Always depress the gear lever and make adjustments to how much pressure is applied to the snowblower.
This is a must.